Scroll Top
Technically Speaking
Wall Review: Prepping for a Project
Prepping for a Project

It’s an unfortunate fact of life that mistakes happen on the jobsite, and mistakes have consequences. It’s also true that some people attempt to cover up their mistakes rather than fixing them, which may alleviate stress in the moment but can lead to much larger issues and damage down the road.

As a craftsman, it is paramount that you care about the work that was done to the wall prior to you getting on the job, not only on account of your professional pride but also because you could be held liable for anything that has been done incorrectly in the past. For masons and other installers of manufactured stone products, this is why it’s important to complete a thorough wall review process before you begin any work.

Pre Work Checklist
As a crucial first step, here is a pre-work checklist you can use to evaluate a wall and decide whether or not to alert the General Contractor or owner of a problem before you start any work on a new project:
Start With An Evaluation Of
  • Is the wall plumb within ¼”?
  • Are corners square within a degree or two?
  • Has sheathing been properly gapped? Failure to provide that 1/8” gap between sheets can cause cracking later when sheathing expands and has nowhere to go.
Next, Let’s Look At The
  • Is the first layer of Water Resistive Barrier (WRB) installed, lapped correctly and integrated with flashing?
  • Are all layers in shingle flashing?
  • Are there any tears or damage to the WRB that needs to be repaired?
  • How long has the WRB been exposed? Most manufacturers have stated limits on exposure. If the WRB has been exposed to UV too long, you need to alert the owner.
  • Do windows have head flashings, and are horizontal/vertical cladding terminations and transitions flashed?
  • Are penetrations for mechanical systems flashed?
Who’s Doing The Flashing
  • This question is almost as important as who’s doing the stone work. If you are responsible for flashing, take ownership and follow tested details produced by NCMA and the WRB manufacturer.
  • Take time to verify any flashing or air sealing tape you use is compatible with the WRB product. If you are not responsible, go on record as such, but still evaluate the flashing done by others.
  • If you find something that doesn’t look like your NCMA details, you need to disclose this to the owner.
Check Proper Flashing On
  • This is a great time to look at adjacent cladding and roofing systems for proper flashing where they intersect with the stone installation.
  • Is a kickout flashing in place? Roof runoff water can flood your new stone installation to the point of failure, so take time now to point this out to your customer.
  • Are interior trades, like wallboard, or exterior, like roofing, all done? Adding these products during or after your stone install can lead to movement and increased crack risk.
Lastly, Let’s Discuss The
  • Discuss where grade will land and that your stone installation needs to be held up off grade or a paved surface.
Share Your Evaluation

With your pre-work checklist completed, you can better determine if the job is ready for you, or if you need to reach out to the owner to make corrections first. Going through these steps confirms to your customers that you are a true craftsman who can be trusted with the project at hand and any future work. 

...Incorporating a pre-work checklist into your job evaluation process provides a professional precedent for your customers.

 If used frequently, not only will your regular customers become accustomed to the process, but you might also find that future jobs are more readily prepared for you to start once you arrive.

Additional Resources

If you would like to learn more about drainage planes and water management, there are many resources available. Here’s a link to get you started:

Learn more about manufactured stone veneer installation and preparation: